Discount Pool Zone
        Swimming Pool Supplies & Parts



Pool Supplies

Home
Pool Cleaners
Pool Filters
Filter Elements
Filter Cartridges
DE Grids

Pool Pumps
Pump Motors
Spa Blowers
Timers
Pool Lights
Pool Accessories
Pool Test Kits
Valves (Multiport)
Pool Chlorinators
Salt Generator
Pump Baskets
Skimmer Baskets
Pool Chemicals
Spa Chemicals
Pool Solar Blankets

Pumps/Fillters Parts

Pool Cleaners
  Pool Vac Navigator
  Hayward Aquabug
  Baracuda®
  StaRite Great White
  Kreepy Krauly


O-rings

Formerly A.O. Smith Electrical Products Company
 
      
         Pool Pump Motors


    

Hayward Super II Pump

    Single Speed (Round Flange)
    RPM 3450
    Frame 56J

Pump Model
AO Smith
Replacement
HP
Volts
Max Amps
Service Factor
Price

SP3005X7AZ
UST1072
3/4
115/230
11.0/5.5
1.0
$119.99
SP3007X10AZ
UST1102
1
115/230
15.0/7.5
1.1
$119.99
SP3010X15AZ
UST1152
1-1/12
115/230
18.6/9.3
1.0
$139.99
SP3015X20AZ
UST1202
2
115/230
19.4/9.7
1.0
$199.99
SP3020X25AZ
UST1252
2-1/2
208-230
11.2
1.0
$299.99

Full Rated Single Speed (Round Flange)
    RPM 3450
    Frame 56J

Pump Model
AO Smith
Replacement
HP
Volts
Max Amps
Service Factor
Price

SP3007EEAZ ST1072
3/4
115/230
15.0/7.5 1.5
$179.99

(Out of Stock)
SP3010EEAZ ST1102
1
115/230
18.6/9.3 1.5
$199.99
SP3015EEAZ ST1152
1-1/12
115/230
19.4/9.7 1.3
$249.99

(Out of Stock)
SP3020EEAZ ST1202
2
208-230
12.6-11.4
1.3
$299.99


Common Seals and Orings that may need to be replaced when replacing the pump motor

Shaft Seal PS-201
$8.99

If you have a Ozone or Salt Pool we recommend Shaft Seal PS-3868 vs the PS-201
$12.99
Housing Gasket SPX3000T (Aladdin Replacement Gasket G345)
$5.99



Kit contains all the seals for the Hayward Super Pump 2 (Salt Systems should use a different Shaft Seal)
Go-Kit-2
$23.99


Motor Failure:

Shaft seal failure is the major cause of motor failure. This allows moisture to go back to the motor causing corrosion and much more. One of the causes of a shaft seal going bad is the result of the pump running dry which heats up all the parts inside the pump causing damage. It's always best to replace the shaft seal when installing a new motor. If the motor fails due to water damage it can void the manufactures warranty.


All A.O. Smith Motors carry a one year manufacturers warranty (Water damage is not covered).
 
ATTENTION: Improperly wiring a motor will cause irreversible damage. If the motor runs slowly then trips out, it is incorrectly wired. Please carefully read the motor name plate regarding the connections. 115/230 volt motors are shipped from the factory connected for 230 volts. A motor connected for 115 volts that has 230 volts applied will burn up immediately. A motor connected for 230 volts that has 115 volts applied will run slowly and trip out. If the wires moved on the connection board are not replaced on the proper terminals, the result will be a slow running motor that overheats and trips out. These motors have automatic overload protection, which means the motor will not run again until it cools down. If you are experiencing problems, please recheck the connections to insure you have the motor properly wired for the incoming voltage. These motors have been test run at the factory, and they very rarely have problems. Problems are almost always related to improper wiring or other installation issues. Please be sure that you are ordering the correct motor and that follow all installation instructions carefully.




Florida Residents
Effective 3/15/12 Florida has a new law governing pool pumps and pool pump motors.

The new law requires Florida residents that need a new pump or motor, 1 HP or larger,
must either replace with a 2 speed or have a variable speed motor. 
These can be viewed thru these links-->  Pumps --- Motors

The new law can be read thru this link "New Law"


                 


Policies           Shipping          Contact

Discount Pool Zone, LLC
611 Overhill Dr
Brandon, FL 33511
Local 813.689.5800
Toll Free 877.222.6122

Your Discount Swimming Pool Supplies Headquarters