Pool Test Kits
Pool Solar Blankets
Pool Vac Navigator
StaRite Great White
Dyna-Glas and Dyna-Max Pump
Common Seals and Orings that may need to be replaced when replacing the pump motor
Shaft Seal PS-201
Seal Plate Core O-ring U9-373 (Aladdin Replacement O-ring O-469)
Diffuser O-ring U9-374 (Aladdin Replacement O-ring O-83)
All A.O. Smith Motors carry a one year manufacturers warranty (Water damage is not covered).
ATTENTION: Improperly wiring a motor will cause irreversible damage. If the motor runs slowly then trips out, it is incorrectly wired. Please carefully read the motor name plate regarding the connections. 115/230 volt motors are shipped from the factory connected for 230 volts. A motor connected for 115 volts that has 230 volts applied will burn up immediately. A motor connected for 230 volts that has 115 volts applied will run slowly and trip out. If the wires moved on the connection board are not replaced on the proper terminals, the result will be a slow running motor that overheats and trips out. These motors have automatic overload protection, which means the motor will not run again until it cools down. If you are experiencing problems, please recheck the connections to insure you have the motor properly wired for the incoming voltage. These motors have been test run at the factory, and they very rarely have problems. Problems are almost always related to improper wiring or other installation issues. Please be sure that you are ordering the correct motor and that follow all installation instructions carefully.
Sta-Rite Dyna-Glas Pump