Discount Pool Zone
        Swimming Pool Supplies & Parts


Pool Supplies

Home
Pool Cleaners
Pool Filters
Filter Elements
Filter Cartridges
DE Grids

Pool Pumps
Pump Motors
Spa Blowers
Timers
Pool Lights
Pool Accessories
Pool Test Kits
Valves (Multiport)
Pool Chlorinators
Salt Generator
Pump Baskets
Skimmer Baskets
Pool Chemicals
Spa Chemicals
Pool Solar Blankets

Pumps/Fillters Parts

Pool Cleaners
  Pool Vac Navigator
  Hayward Aquabug
  BaracudaŽ
  StaRite Great White
  Kreepy Krauly


O-rings


Merchant Services




Formerly A.O. Smith Electrical Products Company

Centurion  .75 HP Threaded Shaft Motor


B625



.75 HP Square Frame Threaded  Shaft

B625
$169.99




PS1000 Polaris Shaft Seal
$8.99
O-299 Polaris Bracket O-ring
$5.99
O-39 Polaris Shaft O-ring
$2.99




Use this motor as a replacement motor for your Polaris Booster Pump.
NOTE: This motor is for the PB4-60. It will not fit the PB4-60Q (quiet version).

AO Smith Motors Century 3/4HP 115/230V Pool Cleaner Pump Motor. Features include:

HP: 3/4
RPM: 3600
Volts: 115/230
Service Factor Amps: 6.4/12.8
Service Factor: 1.50
Frame: 56CZ
Shaft: Threaded


These motors carry a 12 month manufacturers warranty (Water damage is not covered).

ATTENTION: Improperly wiring a motor will cause irreversible damage. If the motor runs slowly then trips out, it is incorrectly wired. Please carefully read the motor name plate regarding the connections. 115/230 volt motors are shipped from the factory connected for 230 volts. A motor connected for 115 volts that has 230 volts applied will burn up immediately. A motor connected for 230 volts that has 115 volts applied will run slowly and trip out. If the wires moved on the connection board are not replaced on the proper terminals, the result will be a slow running motor that overheats and trips out. These motors have automatic overload protection, which means the motor will not run again until it cools down. If you are experiencing problems, please recheck the connections to insure you have the motor properly wired for the incoming voltage. These motors have been test run at the factory, and they very rarely have problems. Problems are almost always related to improper wiring or other installation issues. Please be sure that you are ordering the correct motor and that follow all installation instructions carefully.

B625 Motor


                 


Policies           Shipping          Contact

Discount Pool Zone, LLC
611 Overhill Dr
Brandon, FL 33511
Local 813.689.5800
Toll Free 877.222.6122

Your Discount Swimming Pool Supplies Headquarters